Past exam question: 2071 Chaitra, Q9
Open in the Padhaiko appDefine multiplexing. Explain the working mechanism of WDM. Differentiate between synchronous and statistical TDM. How is spread spectrum utilized in CDMA? What are the advantages and disadvantages of CDMA?
Solution
1. Definition of Multiplexing: Multiplexing is the set of techniques that allows multiple independent information streams to share a common physical communication channel simultaneously, optimizing transmission medium bandwidth and reducing infrastructure cost.
2. Working Mechanism of WDM: Wavelength Division Multiplexing (WDM) is an optical analog multiplexing technique that combines multiple optical carrier signals of distinct laser wavelengths onto a single optical fiber strand.
- Working Principle: Optical transmitters emit data on narrow, distinct wavelengths () within the low-loss optical windows ( or ).
- An optical multiplexer (diffraction grating or prism) merges these light beams into a single fiber.
- At the destination, an optical demultiplexer separates the composite beam by wavelength into individual photoreceivers.
- DWDM (Dense WDM): Packs channels very closely (channel spacing / ), allowing over 100 terabits/s on a single strand.
3. Synchronous vs Statistical TDM:
| Parameter | Synchronous TDM | Statistical (Asynchronous) TDM |
|---|---|---|
| Slot Allocation | Fixed time slots assigned dedicatedly to each source, regardless of whether it has active data. | Dynamically allocated time slots granted only to sources that currently have data to send. |
| Bandwidth Efficiency | Low when sources are idle (idle slots carry blank padding). | High; fully utilizes all time slots through statistical sharing. |
| Addressing Overhead | Zero header overhead; slot position implicitly identifies the source. | Requires address/channel identification bits in every slot. |
| Buffer Requirements | Minimal buffering needed. | Requires input queues to buffer incoming burst traffic. |
4. Spread Spectrum Utilization in CDMA: In Code Division Multiple Access (CDMA), Direct Sequence Spread Spectrum (DSSS) is employed:
- Every active user is assigned a unique, mutually orthogonal pseudo-random code sequence (Walsh code / PN sequence) consisting of chips per bit.
- The user's low-rate data signal is multiplied by this high-rate chip sequence, spreading signal power over a wide RF bandwidth.
- All users transmit simultaneously across the exact same frequency band.
- At the receiver, the composite signal is correlated (inner product) with the target user's specific code. Due to orthogonality ( for ), all other user signals act as low-power uncorrelated background noise.
5. Advantages and Disadvantages of CDMA:
- Advantages:
- High spectral capacity (frequency reuse factor of 1 across all adjacent cells).
- Soft capacity limit: Adding users gracefully degrades SNR without hard call blocking.
- Inherent security and resistance to multipath fading via Rake receivers.
- Disadvantages:
- Strict requirement for precise power control (Near-Far problem: a close transmitter can drown out a distant one if power is not matched).
- Complex receiver signal processing and tight synchronization requirements.
Multiplexing shares a single medium across multiple channels; WDM multiplexes distinct optical wavelengths over one fiber. Synchronous TDM uses fixed slots (wasting idle slots, no addressing), whereas statistical TDM assigns slots dynamically to active sources. CDMA multiplies each user's data by an orthogonal PN spreading code so all users share the full band simultaneously; it offers soft capacity, interference resistance, and security, but suffers from the near-far problem and complex receiver synchronization.