PadhaikoAll subjects

Past exam question: 2079 Baishakh (Back), Q1(a)

Data Communication · 4 marks

Open in the Padhaiko app

Topic: Data Communication Fundamentals

Question

What are the different types of data transmission technology?

Solution

Classification of Data Transmission Technologies by Flow Direction and Synchronization: Data transmission technologies encompass the physical and logical mechanisms used to transfer digital or analog information between communicating entities over a transmission medium. They are classified systematically along several technical dimensions:

  1. Directionality of Information Flow (Transmission Modes):
    • Simplex: Unidirectional communication where data travels strictly in one predetermined direction (e.g., commercial radio/television broadcast, keyboard to CPU). The receiver cannot reply.
    • Half-Duplex (HDX): Bidirectional communication where both stations can transmit and receive, but only one entity can transmit at any given instant (e.g., Walkie-Talkies, traditional push-to-talk radio systems). The full bandwidth is alternately shared in time.
    • Full-Duplex (FDX): Simultaneous bidirectional communication where both stations can transmit and receive data concurrently (e.g., modern switched Ethernet, mobile telephone networks). This requires either two physical transmission paths or channel division via FDD (Frequency Division Duplexing) or TDD (Time Division Duplexing).

Classification by Signal Alignment, Synchronization, and Baseband Transport:

  1. Timing and Clock Synchronization (Serial Transmission):
    • Asynchronous Transmission: Bits are grouped into small independent characters (usually 1 byte) framed by explicit start bits (logic 0) and stop bits (logic 1), with variable idle gaps between characters. The receiver re-synchronizes its local clock on each start bit transition. Ideal for low-speed, bursty data (e.g., RS-232 serial interfaces).
    • Synchronous Transmission: Data bits are transmitted as continuous, unbroken blocks or frames governed by a common shared clock or clock signal embedded directly within the line code (e.g., Manchester encoding). Preamble and sync flags demarcate frame boundaries. Provides high spectral efficiency and throughput for high-speed networks.
  2. Spatial Organization of Data Channels:
    • Parallel Transmission: Multiple bits ( bits) are sent concurrently over separate physical wires (plus ground and clock) per clock tick (e.g., internal CPU bus, older IEEE-1284 printer ports). High speed over very short distances, but suffers from wire skew and crosstalk at high frequencies.
    • Serial Transmission: Bits are transmitted sequentially, one bit at a time, across a single channel/wire pair (e.g., USB, PCIe, Ethernet, SATA). Dominates modern high-speed communication because it eliminates propagation skew across lines.
  3. Signaling Domain (Baseband vs. Broadband):
    • Baseband Transmission: Digital pulses are placed directly onto the medium without frequency translation, occupying spectrum starting from DC () up to the cutoff frequency. Used in LANs (Ethernet).
    • Broadband Transmission: Digital or analog data modulates a high-frequency analog sinusoidal carrier, enabling frequency-division multiplexing (FDM) of multiple independent channels across a shared wideband medium (e.g., cable TV networks, DSL).
Answer:

Data transmission technologies are classified by:

  1. Directionality: Simplex (unidirectional), Half-Duplex (alternating bidirectional), Full-Duplex (simultaneous bidirectional).
  2. Synchronization: Asynchronous (start/stop framed per character, bursty) and Synchronous (clocked frame blocks, continuous high speed).
  3. Channel organization: Parallel ( wires simultaneously, short distance) and Serial (single wire sequentially, long distance).
  4. Signaling type: Baseband (unmodulated digital pulses from DC) and Broadband (modulated high-frequency carrier).

All past exam questions for Data Communication