Transient Analysis Using Laplace Transform
Open in the Padhaiko app3.1 Introduction
The Laplace transform turns the differential equations of a circuit into algebraic equations in , and it builds the initial conditions into the equations. The complete response (transient plus steady state) comes out in one step.
Laplace Transform and Circuit Models
Element models in the -domain (initial conditions , ):
- Resistor: .
- Inductor: (impedance in series with a source ), or .
- Capacitor: (impedance in series with a source ).
| for | |
|---|---|
| (DC step) | |
3.2 Response of R-L and R-C circuits
For a series R-L circuit , and for a series R-C circuit .
3.2.1 DC excitation
With the R-L response is , which gives , the same as the classical method.
3.2.2 Exponential excitation
With the denominator is . Partial fractions give one term (forced) and one term (natural).
3.2.3 Sinusoidal excitation
With the denominator is . The quadratic factor gives the steady-state sine and cosine, and the pole at gives the transient.
3.3 Response of series R-L-C circuits
For a relaxed series circuit .
Poles and Damping
The poles are the roots of . Two real poles mean overdamped, a double real pole critically damped, and a complex pair underdamped. The partial-fraction form matches the damping case directly (Chapter 2).
3.3.1 DC excitation
For : . Invert by the pair table with the poles above.
3.3.2 Exponential excitation
For : . The pole at gives the forced term and the other two give the natural response.
3.3.3 Sinusoidal excitation
For : . The poles give the steady-state current and the other two poles give the transient.
3.4 Response of parallel R-L-C circuits
For a current source the voltage is .
3.4.1 DC excitation
With : . Then and for a relaxed circuit.
3.4.2 Exponential excitation
With : . The pole at gives the forced term.
3.1
A DC source is switched on to in series with . The inductor carries just before switching. Find by the Laplace method.
-domain equation. The inductor adds a source volts in the loop:
Partial fractions.
Inverse transform. A. Check: and .
.
3.2
A relaxed series circuit has , and source . Find .
-domain current. and :
Partial fractions. Write . At : . Matching gives so . Matching gives so .
Inverse.
Check: , as it must be, because the source voltage is zero at and the capacitor is uncharged.
.
3.3
A relaxed series circuit has , , and a DC source switched on at . Find .
-domain. .
Partial fractions. , since the residues are and .
Inverse. . The circuit is overdamped because both poles are real.
.
Exercises
Practice Exercises: Laplace Transient Analysis
Describe the -domain equivalents of an inductor and a capacitor with initial conditions, and state why the Laplace method needs no separate step for constants.
Inductor. : an impedance in series with a voltage source opposing the current. Alternatively, in parallel with a current source .
Capacitor. : an impedance in series with a source .
Constants. Initial conditions enter as sources in the algebraic equation, so the result already satisfies them.
with series source ; with series source ; initial conditions are built in.
A relaxed series circuit with , has applied at . Find .
-domain. .
Partial fractions. and .
(note ).
A relaxed series R-L circuit with , is connected at to . Find by Laplace transform.
-domain. .
Partial fractions. at . Matching : so . Matching : so .
Inverse. , so . The sine-cosine pair equals .
.
A relaxed series circuit has , , with a DC source switched on. Find and its type of damping.
-domain. . The poles are .
Inverse. From the pair with : . Underdamped.
, underdamped.
A DC current source is switched on across a relaxed parallel circuit with , , . Find .
-domain. .
Inverse. The double pole at means critical damping: .
.