Magnetic Circuit and Induction
Open in the Padhaiko app6.1 Magnetic circuit and its types
Magnetic Circuit
A magnetic circuit is the closed path followed by magnetic flux (weber), usually through iron with perhaps an air gap. The driving quantity is the magnetomotive force ampere-turns. Key quantities:
Reluctance (A/Wb) opposes the flux, and the magnetic Ohm's law is .
| Magnetic | Electric |
|---|---|
| mmf (AT) | emf (V) |
| flux (Wb) | current (A) |
| reluctance | resistance |
| permeability | conductivity |
| flux density | current density |
Types of Magnetic Circuit
- Series circuit: the same flux passes through each section (core and air gap), so reluctances add: and .
- Parallel circuit: flux divides between branches (e.g. the three-limb core), so branch mmf drops are equal and .
- Composite circuit: series and parallel parts, or different materials, areas and an air gap.
Because the air gap has , a gap of even often needs more ampere-turns than the whole iron path. Fringing makes the effective gap area slightly larger than the core area.
6.2 B-H relationship and hysteresis with DC excitation
B-H Curve and Hysteresis
A ferromagnetic material starting unmagnetised follows the magnetisation curve: rises almost linearly, bends at the knee and then saturates, where falls. If is reversed slowly through a full cycle, lags behind and traces a closed hysteresis loop.
- Retentivity : flux density left when .
- Coercivity : reverse field needed to bring to zero.
- The area of the loop is the energy lost per unit volume per cycle (J/m), turned into heat as the domains reorient.
| Property | Soft (silicon steel) | Hard (steel, alnico) |
|---|---|---|
| Loop shape | narrow, tall | wide |
| Coercivity | low | high |
| Hysteresis loss | low | high |
| Use | transformers, machines | permanent magnets |
6.3 Hysteresis with AC excitation
With sinusoidal current the flux density swings between and each cycle, so the loop is traversed times per second. A sine voltage across a coil of turns demands a sinusoidal flux with ; the magnetising current then has a peaked, non-sinusoidal shape because of saturation and carries a small component in phase with voltage for the core loss.
6.4 Hysteresis loss and eddy current loss
Hysteresis and Eddy Current Loss
- Hysteresis loss (Steinmetz):
where is the Steinmetz coefficient (J/m per cycle at ), the core volume. It is reduced by silicon steel (low-loss, narrow loop).
- Eddy current loss: the alternating flux induces circulating currents in the core itself:
with lamination thickness . It is reduced by laminating the core into thin insulated sheets and by adding silicon, which raises resistivity.
Total core (iron) loss . At constant , and .
6.5 Faraday's law of electromagnetic induction, statically and dynamically induced EMF
Faraday's Law
When the flux linked with a coil changes, an emf is induced equal to the rate of change of flux linkage:
The minus sign (Lenz's law) shows that the induced emf drives a current that opposes the change that caused it.
- Dynamically induced emf: the conductor moves in a steady field, ( is the angle between and ). Direction by Fleming's right-hand rule. This is the generator principle.
- Statically induced emf: the conductor is stationary and the flux changes, in two forms. Self-induced: with . Mutually induced: in a neighbouring coil. This is the transformer principle.
6.6 Force on current carrying conductor
Force on a Conductor
A conductor of length carrying current in a field experiences
at right angles to both and the conductor, found by Fleming's left-hand rule. This is the motor principle. The force between two long parallel conductors a distance apart is , attractive when the currents are in the same direction.
6.1
A ring core has mean iron length , cross-section , and a air gap. A coil of turns must produce . Find the reluctances and the exciting current.
Flux. .
Reluctances.
The gap is of the length but has twice the reluctance of the iron.
Current. , so .
, ; ; .
6.2
The core loss of a transformer at and rated flux density is , of which is hysteresis and is eddy-current loss. Find the loss at and at if is kept constant.
Scaling. and at constant .
At . and . Total .
At . and , total .
at ; at .
6.3
(a) A conductor moves at perpendicular to a field. Find the induced emf. (b) The flux linked with a -turn coil falls from to in . Find the average emf. (c) The conductor carries in the same field: find the force when it is perpendicular and when it makes with the field.
(a) .
(b) .
(c) . At : .
(a) ; (b) ; (c) and .
Exercises
Practice Exercises: Magnetic Circuit and Induction
Explain the hysteresis loop, defining retentivity and coercivity, and state how hysteresis and eddy-current losses are minimised in a transformer core.
Loop. When is cycled, lags behind . At the remaining flux density is the retentivity . The reverse that reduces to zero is the coercivity . The loop area equals the energy lost per unit volume per cycle.
Minimising. Hysteresis loss is reduced by using silicon steel with a narrow loop. Eddy-current loss is reduced by thin insulated laminations and by the high resistivity of silicon steel.
Narrow-loop silicon steel and thin laminations.
A core of mean length , area and has a gap. Find the ampere-turns and the current in a -turn coil to produce a flux of .
Flux density. .
Core and gap. so . so .
Total. , so .
and .
A core of volume has Steinmetz coefficient . Find the hysteresis loss at for and .
Formula. . .
Values. At : . At : (increase of , same as the frequency ratio).
and .
A coil of self-inductance carries a current that rises uniformly from to in . Find the induced emf and the change in stored energy.
EMF. , opposing the rise (Lenz).
Energy. .
and .
(a) A conductor carrying lies in a field. Find the force when it is at and at to the field. (b) Find the force per metre between two parallel conductors apart each carrying in the same direction.
(a) : at ; at .
(b) , attractive.
(a) and ; (b) attractive.