PadhaikoAll subjects

Catalyst and Catalysis

Engineering Chemistry (ENSH 153)

Open in the Padhaiko app

2.1 Definition and types

Definition

Catalyst and Catalysis

A catalyst is a substance that changes the rate of a chemical reaction by providing an alternative pathway of lower activation energy, and is regenerated unchanged in mass and chemical composition at the end of the reaction. The phenomenon is catalysis.

A catalyst does not change the position of equilibrium or (it speeds the forward and reverse reactions equally), cannot start a thermodynamically non-spontaneous reaction, and is usually needed only in small amounts. Rate constants follow the Arrhenius equation , so lowering raises exponentially.

Types of Catalysis
TypeDefinitionExample
HomogeneousCatalyst and reactants in the same phaseAcid-catalysed hydrolysis of an ester; in the lead-chamber oxidation of
HeterogeneousCatalyst in a different phase, usually solid with gaseous or liquid reactantsFe in Haber's process ; in contact process; Ni in hydrogenation
Enzyme (bio-) catalysisProtein catalysts, highly specific, work at mild conditionsInvertase for sucrose; urease for urea
AutocatalysisA product of the reaction acts as its catalyst in oxidation of oxalic acid
Positive and negativeCatalyst increases or decreases the rate (inhibitor)Pt for oxidation; glycerol slows decomposition

Further terms: a promoter increases the activity of a catalyst (Mo in the Fe catalyst of the Haber process), and a poison reduces it by blocking active sites ( on Pt; Pb on a catalytic converter).

Mechanism of heterogeneous catalysis (adsorption theory): reactants diffuse to the surface, are adsorbed at active sites, react in the adsorbed state with a lower barrier, products desorb, and the sites are free again. The fraction of the surface covered at pressure follows the Langmuir isotherm

Example 2.1

2.1

(a) A catalyst lowers the activation energy of a reaction from to . By what factor does the rate constant increase at if is unchanged? (b) A reaction makes of product using of catalyst in ; find the turnover number and the turnover frequency. (c) A gas adsorbs on a catalyst with ; find the surface coverage at .

(a) Rate enhancement:

(b) Turnover number and frequency:

(c) Langmuir coverage:

Answer:

(a) About -fold; (b) , ; (c) .


2.2 Design and criteria

2.2.1 Structure-activity relationships

The activity and selectivity of a catalyst depend on its structure at the atomic scale.

2.2.2 Selection criteria of a catalyst

Criteria for Selecting an Industrial Catalyst
CriterionMeaning
ActivityHigh rate per unit mass or per active site (TOF) under mild temperature and pressure
SelectivityForms the desired product with little by-product, which also saves separation costs
Stability and lifetimeResists sintering, poisoning, fouling (coke) and leaching; can be regenerated
Mechanical strengthWithstands crushing, abrasion and pressure drop in the reactor
Cost and availabilityCheap, abundant material, or a precious metal used in very small amount and recovered
Environmental safetyNon-toxic, easy to separate and recycle (heterogeneous catalysts are separated by filtration)

2.3 Photocatalysis and electrocatalysis

Photocatalysis uses light to activate a catalyst. In a semiconductor photocatalyst such as , a photon with energy excites an electron from the valence band to the conduction band, leaving a hole.

The threshold wavelength is . For anatase with , (ultraviolet), so doping (N, Fe) or coupling with dyes is used to reach visible light.

Electrocatalysis is catalysis of an electrode reaction: the catalyst on the electrode lowers the overpotential so that a given current is reached at a smaller potential. Examples are:

Electrocatalysts and the Reactions They Catalyse
ReactionElectrocatalyst
Hydrogen evolution (HER), Pt (best), Ni-Mo,
Oxygen evolution (OER), , , Ni-Fe oxides
Oxygen reduction (ORR) in fuel cellsPt/C, Fe-N-C
reductionCu (to hydrocarbons), Ag and Au (to CO)

A good electrocatalyst has a high exchange current density , a low Tafel slope, and long-term stability in the electrolyte.


2.4 Catalysis for energy and environmental applications

2.4.1 Catalytic conversion of fossil fuels

Catalytic Processes of the Fuel Industry
ProcessReaction or aimCatalyst
Catalytic crackingLarge hydrocarbons break into gasoline-range alkanes and alkenesZeolite (acid)
Catalytic reformingStraight-chain alkanes become branched and aromatic (higher octane)Pt-Re on
HydrodesulfurizationRemoves sulfur: Co-Mo or Ni-Mo on
Steam reforming of methaneNi
Water-gas shiftFe-Cr oxide or Cu-Zn
Fischer-Tropsch synthesisCo or Fe
Haber process (ammonia)Fe with and promoters

2.4.2 Renewable energy catalysts

2.4.3 Catalyst for pollution control

Definition

Catalytic Converter

The three-way catalytic converter of a petrol vehicle contains Pt, Pd and Rh dispersed on an alumina washcoat over a ceramic honeycomb. It converts three pollutants at once:

It works only with a near-stoichiometric air-fuel ratio and must be protected from lead (poison); therefore unleaded fuel is required.

Selective catalytic reduction (SCR) for diesel engines and power plants removes with ammonia (or urea) over : . Other examples are catalytic oxidation of volatile organic compounds, and photocatalytic degradation of dyes in waste water.

Example 2.2

2.2

Exhaust gas contains of CO. In the three-way converter all of it reacts with NO by . Find the mass of formed and the volume of formed at STP (, , ). Also find the longest wavelength that can excite anatase ().

Moles of CO: , so .

Products (from the balanced equation, 2 CO : 2 CO : 1 N): , mass . , volume at STP.

Threshold wavelength:

Answer:

of ; of ; (UV).


Exercises

Practice Exercises — Catalysis

Question 1

Define catalyst and catalysis. State four characteristics of a catalyst and distinguish between homogeneous and heterogeneous catalysis with two examples each.

Definition and characteristics: A catalyst alters the rate of a reaction through an alternative path of lower activation energy and is recovered unchanged. Characteristics: it is unchanged in mass and chemical nature; a small amount is enough; it does not change the equilibrium constant or ; it is often specific; and it cannot initiate a non-spontaneous reaction.

Comparison: In homogeneous catalysis the catalyst is in the same phase as the reactants (acid catalysing ester hydrolysis; in oxidation of ), whereas in heterogeneous catalysis it is in a different phase (Fe in the Haber process; in the contact process). Heterogeneous catalysts are easily separated by filtration.

Answer:

A catalyst lowers without being consumed. Homogeneous: same phase; heterogeneous: different phase.

Question 2

A catalyst lowers the activation energy from to for a reaction at . Find the factor by which the rate constant increases and explain why the equilibrium constant remains unchanged.

Rate enhancement:

Equilibrium: The catalyst lowers the barrier of the forward and reverse reactions by the same amount, so is unchanged; it only shortens the time to reach equilibrium.

Answer:

The rate constant increases about -fold; is unchanged.

Question 3

Explain how particle size, support and d-band electronic structure affect the activity of a catalyst. Calculate the ratio of specific surface areas of gold nanoparticles () of diameters and and state the specific area of the sample.

Structure-activity ideas: Smaller particles give more surface atoms and more low-coordination edge and corner sites; a support disperses them and stops sintering; the d-band position fixes the adsorption strength, and the best catalysts bind reactants with intermediate strength (volcano plot).

Numbers ():

The ratio is .

Answer:

Ratio ; (against for ).

Question 4

Describe photocatalysis with reference to , and distinguish photocatalysis from electrocatalysis. Name suitable electrocatalysts for the hydrogen and oxygen evolution reactions.

Photocatalysis on : UV light with excites an electron into the conduction band leaving a hole. The hole forms radicals and the electron forms ; both oxidize organic pollutants to and .

Comparison and examples: In photocatalysis light energy activates the semiconductor catalyst; in electrocatalysis an applied potential drives the reaction at an electrode surface and the catalyst lowers the overpotential. HER: Pt (or , Ni-Mo); OER: , or Ni-Fe oxide.

Answer:

Photocatalysis: light excites a semiconductor; electrocatalysis: potential drives the electrode reaction. HER: Pt; OER: /.

Question 5

With a balanced equation, explain the working of a catalytic converter and of SCR. In SCR, ; how many grams of are needed to remove of NO (, , )?

Converter and SCR: In the three-way converter Pt/Pd/Rh oxidize CO and hydrocarbons to and , and Rh reduces NO: . In SCR, ammonia reduces NO to harmless over even in oxygen-rich exhaust.

Ammonia needed: . The equation shows , so and mass .

Answer:

of .

← Electrochemistry and BufferAnalytical Techniques and their Applications →