PadhaikoAll subjects

Analytical Techniques and their Applications

Engineering Chemistry (ENSH 153)

Open in the Padhaiko app

3.1 Chromatography

Chromatography separates the components of a mixture by their different distribution between a stationary phase (fixed) and a mobile phase (moving). A component that is held strongly by the stationary phase moves slowly; one that prefers the mobile phase moves fast.

Types of Chromatography
TechniqueStationary phaseMobile phasePrinciple and use
Paper chromatographyWater held in cellulose paperLiquid solventPartition; amino acids, dyes
Thin-layer (TLC)Silica or alumina layer on a plateLiquid solventAdsorption; quick purity checks and reaction monitoring
ColumnSilica or alumina packed in a glass columnLiquid solventAdsorption; separation of mixtures in the laboratory
Gas chromatography (GC)Liquid film on inside of capillary columnInert gas (He, )Partition of volatile compounds; fuels, solvents, pollutants
High-performance liquid chromatography (HPLC)Fine particles (C18 bonded silica)Liquid pumped at high pressurePartition; drugs, food, water analysis
Ion-exchangeResin with fixed charged groupsAqueous bufferIons exchange with the resin; water softening and amino acid analysis

Key quantities.

Applications: purity testing of drugs, detection of pesticides and dyes in food, analysis of petroleum fractions and atmospheric pollutants, forensic analysis, and purification of natural products.

Example 3.1

3.1

(a) A spot moves while the solvent front moves in TLC. Find . (b) In a GC run two peaks appear at and with base widths each. Find the number of plates for the first peak and the resolution.

(a) Retardation factor: .

(b) Plates and resolution:

Since the peaks are only partly resolved.

Answer:

(a) ; (b) , .


3.2 Mass spectroscopy

In mass spectrometry the sample is vaporized and ionized, the ions are accelerated and separated according to their mass-to-charge ratio , and the number of ions at each is recorded as a mass spectrum.

Instrument parts: sample inlet, ion source (electron impact, , which gives the positive molecular ion and fragments; softer methods are electrospray and MALDI), accelerating field, mass analyser (magnetic sector, quadrupole, time of flight) and detector.

Definition

Principle of the Magnetic-Sector Analyser

An ion of charge accelerated through potential gains kinetic energy . In a magnetic field perpendicular to its path it moves in a circle of radius with . Eliminating ,

so for fixed and the radius depends only on ; scanning or brings each to the detector in turn.

Interpretation.

Applications: determination of molar mass and formula, structure elucidation, isotope analysis, detection of drugs, pollutants and proteins, and coupling with GC or HPLC (GC-MS, LC-MS).


3.3 X-ray diffraction (XRD)

X-rays () are diffracted by the regularly spaced atomic planes of a crystal. Constructive interference occurs when the path difference is a whole number of wavelengths (Bragg's law):

where is the spacing of the planes and the glancing angle. A powder diffractometer records the intensity against the angle .

What XRD gives:

with and the peak width (FWHM) in radians. Nanoparticles give broad peaks; a sharp peak means large crystals.

Applications: characterizing cement, alloys, catalysts, minerals, pharmaceuticals and nanomaterials.

Example 3.2

3.2

Gold is face-centred cubic with . (a) Find the spacing of the (111) planes and the angle at which this reflection appears with radiation (, ). (b) If the peak has a width of , estimate the crystallite size ().

(a) Spacing and angle:

(b) Scherrer size: .

Answer:

(a) , ; (b) .


3.4 UV-visible spectroscopy

Ultraviolet ( to ) and visible ( to ) light excites valence electrons from a lower to a higher orbital. The common transitions in order of decreasing energy are (far UV, alkanes), (alcohols, amines, about to ), (alkenes, aromatics, carbonyls) and (carbonyl, weak, longest wavelength). Energy absorbed: .

Definition

Beer-Lambert Law

The absorbance of a solution depends on concentration and path length :

is the molar absorptivity (), characteristic of the compound at wavelength . A plot of against at is a straight line (calibration curve) and is used to find unknown concentrations. Deviations occur at high concentration.

Instrument: source (deuterium lamp for UV, tungsten for visible), monochromator, sample and reference cuvettes (quartz for UV), detector, recorder.

Effect of structure: more extended conjugation lowers the energy gap and shifts to longer wavelength (red or bathochromic shift): ethene , butadiene , -carotene (orange).

Applications: quantitative analysis of metal ions (as coloured complexes), dyes and drugs; kinetics; detection of conjugation and functional groups; band-gap determination in semiconductors.


3.5 Infrared spectroscopy (IR)

Infrared radiation ( to ) is absorbed when its frequency equals a vibrational frequency of a bond and the vibration changes the dipole moment of the molecule. Symmetric diatomics such as and are therefore IR-inactive.

Bonds behave like springs (Hooke's law): the wavenumber is

with the force constant, so stronger bonds and lighter atoms vibrate at higher wavenumber ().

Characteristic IR Absorptions
Bond or groupWavenumber ()Appearance
O-H (alcohol) to Strong, broad
O-H (carboxylic acid) to Very broad
N-H (amine) to Medium
C-H (alkane, alkene, alkyne) to ; to ; Medium to strong
, to Weak to medium
C=O (aldehyde, ketone, ester, acid) to Strong, sharp
C=C to Variable
C-O to Strong

The region below is the fingerprint region, unique to each compound. Applications: identifying functional groups, confirming a compound by comparing its spectrum with a standard, following a reaction (appearance of C=O, loss of O-H), and checking purity and polymers in industry (FTIR instruments).

Example 3.3

3.3

Estimate the stretching wavenumber of the C=O bond using Hooke's law with force constant (). Compare with a strong band observed at and express this in wavelength.

Hooke's-law estimate: .

This agrees with the observed C=O band near .

Wavelength of the observed band:

Answer:

Calculated (observed , a carbonyl group); .


3.6 Nuclear magnetic resonance spectroscopy (NMR)

Nuclei with spin (, ) behave like small magnets. In a strong field they occupy two spin states of different energy, and radio-frequency radiation of the Larmor frequency

flips the spin (resonance). For , , so corresponds to a instrument.

What a NMR spectrum shows:

Typical H Chemical Shifts
Type of proton (ppm)
Alkyl C-H to
H next to C=O or aromatic ring to
H on carbon bonded to O (as in C-O-H or C-O-C) to
Alkene C-H to
Aromatic C-H to
Aldehyde CHO to
Carboxylic acid COOH to

Because is a ratio, it has the same value at any field strength, whereas the shift in hertz is proportional to the spectrometer frequency. Applications: structure determination of organic compounds, purity checks, and (as MRI) medical imaging of water protons.

Example 3.4

3.4

(a) Find the Larmor frequency of in a field of . (b) A proton signal at is observed on a instrument; by how many hertz does it lie from TMS, and how many hertz on a instrument? (c) Predict the NMR spectrum of ethyl acetate, .

(a) Larmor frequency: .

(b) Shift in hertz: : at and at (the same ).

(c) Ethyl acetate: Three kinds of H, so three signals: at (singlet, , no neighbour H); at (quartet, , split by the H of ); at (triplet, , split by the H of ). The integrals are in the ratio .

Answer:

(a) ; (b) and ; (c) singlet (), quartet (), triplet ().


Exercises

Practice Exercises — Analytical Techniques

Question 1

Explain the principle of chromatography and compare TLC with HPLC. In a paper chromatogram two spots lie and from the origin when the solvent front has moved . Find their values and say which is more strongly adsorbed.

Principle and comparison: Components distribute differently between a stationary and a mobile phase and therefore travel at different speeds. TLC uses a thin adsorbent layer and a liquid solvent moving by capillary action, and is fast and inexpensive for qualitative work. HPLC pumps a liquid at high pressure through a column of fine particles and gives quantitative, high-resolution separations with a detector.

values: and . The second compound moved less, so it is held more strongly by the stationary phase.

Answer:

and ; the second compound is more strongly adsorbed.

Question 2

Describe the working of a mass spectrometer. Singly charged ions of mass are accelerated through into a field of ; find the radius of their path. How would a molecule containing one chlorine atom appear in the mass spectrum?

Working: The sample is vaporized and ionized (electron impact), the ions are accelerated by , deflected by a magnetic field in paths of radius depending on , and counted at the detector, giving a plot of relative abundance against .

Radius:

Chlorine pattern: Two peaks, and , with intensity ratio , from and .

Answer:

; chlorine shows .

Question 3

State Bragg's law. X-rays of wavelength give a first-order reflection at from a crystal; find the spacing of the planes. State two uses of XRD in materials chemistry.

Bragg's law: .

Plane spacing:

Uses: Identifying crystalline phases (for example in cement or catalysts) and estimating crystallite size of nanomaterials by the Scherrer equation.

Answer:

.

Question 4

State the Beer-Lambert law. A solution of absorbance in a cell has . Find its concentration and transmittance. Why does extending the conjugation shift to longer wavelength?

Law and numbers: with :

Conjugation: Extending the conjugated system brings the energy levels of and closer, so a smaller energy excites the electron and increases (butadiene against ethene ).

Answer:

; .

Question 5

An organic liquid of formula shows a strong IR band at , no broad band at , and a single NMR signal at . Identify the compound and explain each observation.

IR evidence: The strong sharp band at is C=O. The absence of a broad O-H band at to rules out an alcohol or acid, leaving an aldehyde or ketone.

NMR evidence: One signal means all six H are equivalent. Two groups on a carbonyl give one singlet at (H next to C=O, no neighbouring H to split it). Propanal () would show three signals including a peak near .

Answer:

Propanone (acetone), .

← Catalyst and CatalysisMetal Complexes, Rare Earth Elements and Metal alloys →