Sustainable Chemistry
Open in the Padhaiko app5.1 Green chemistry: introduction and principles
Green chemistry is the design of chemical products and processes that reduce or eliminate the use and generation of hazardous substances (Anastas and Warner, 1998). It prevents pollution at the source instead of cleaning it up afterwards.
| No. | Principle | Meaning |
|---|---|---|
| 1 | Prevention | It is better to prevent waste than to treat it afterwards |
| 2 | Atom economy | Design syntheses so that most reactant atoms end up in the product |
| 3 | Less hazardous synthesis | Use and generate substances of little or no toxicity |
| 4 | Designing safer chemicals | Products should do their job with minimal toxicity |
| 5 | Safer solvents and auxiliaries | Avoid solvents and separation agents, or use harmless ones such as water or supercritical |
| 6 | Energy efficiency | Work at ambient temperature and pressure where possible |
| 7 | Renewable feedstocks | Use renewable raw materials (biomass) instead of depleting ones |
| 8 | Reduce derivatives | Avoid blocking and protecting groups and unnecessary steps |
| 9 | Catalysis | Selective catalysts are better than stoichiometric reagents |
| 10 | Design for degradation | Products should break down to harmless substances after use |
| 11 | Real-time analysis | Monitor the process to prevent pollution formation |
| 12 | Inherently safer chemistry | Choose substances and forms that minimise accidents (explosions, fires, releases) |
Measures of greenness.
A low -factor and a high atom economy mean a greener process (bulk chemicals to ; fine chemicals and pharmaceuticals to over ).
5.1
Ethylene oxide () is made (i) by the chlorohydrin route, , and (ii) by direct catalytic oxidation, . Compare their atom economies (, , , ). A plant making of a product generates of waste; find its -factor.
(i) Chlorohydrin route:
(ii) Direct oxidation:
every reactant atom ends in the product, and a catalyst (silver) is used (principles 2 and 9).
-factor: .
Chlorohydrin: ; direct oxidation: ; .
5.2 Water chemistry
5.2.1 Importance of water quality standards
Water used for drinking, industry and irrigation must meet quality standards so that it does not carry disease, toxic chemicals or scale-forming salts. Standards fix limits for physical (turbidity, colour, taste, temperature), chemical (, total dissolved solids, hardness, chloride, nitrate, fluoride, arsenic, iron, heavy metals) and biological (coliform bacteria) parameters. They protect public health, guarantee safe use in industry (boilers, food, pharmaceuticals), guide treatment plants, and provide a legal basis to control pollution. Examples of drinking-water limits (WHO and the Nepal drinking water quality standard) are to , turbidity , total dissolved solids , total hardness as and arsenic (WHO guideline ), and zero coliform per .
5.2.2 Degree of hardness, scale formation in boilers and softening of hard water
Hardness is the property of water that prevents it from forming lather with soap, due to dissolved salts of and : .
| Type | Cause | Removal |
|---|---|---|
| Temporary (carbonate) | Bicarbonates of Ca and Mg: , | Boiling: |
| Permanent (non-carbonate) | Chlorides and sulfates of Ca and Mg: , , , | Chemical softening (lime-soda, zeolite, ion exchange) |
Degree of hardness is expressed as the equivalent amount of (molar mass ), in ():
Total hardness temporary permanent. It is determined by titration with EDTA (Eriochrome Black T indicator, pH buffer): mg/L.
Scale formation in boilers. On continuous evaporation the dissolved salts concentrate and deposit as hard scale (, , , silica) on the boiler walls. Scale has low thermal conductivity, so it wastes fuel, overheats the metal and may cause explosions, and it reduces the water flow in tubes. Related troubles are sludge (soft, loose deposit), priming and foaming (carry-over of water in steam), caustic embrittlement (cracking of steel by ) and corrosion by dissolved and .
Softening of hard water.
- Lime-soda process: lime removes temporary hardness and salts; soda ash removes permanent hardness. Lime needed and soda needed (all in as ), per litre of water.
- Zeolite (permutit) process: hydrated sodium aluminosilicate exchanges for and : . The bed is regenerated with brine ( ).
- Ion-exchange (demineralization): a cation resin () exchanges all cations for and an anion resin () exchanges all anions for , giving water of nearly zero hardness. Regeneration uses acid and alkali.
- Internal treatment: phosphate () precipitation, Calgon (sodium hexametaphosphate) and colloidal conditioning inside the boiler.
5.2
A water sample contains (in ) , , , and (molar masses , , , , ). Find the temporary, permanent and total hardness as . Also, of another sample needs of EDTA; find its hardness. For of water with permanent hardness, find the soda required, and for due to only, the lime required.
Hardness in equivalents:
Temporary hardness , permanent hardness , total .
EDTA titration:
(very hard water).
Soda and lime: Soda of . Lime of .
Temporary , permanent , total ; EDTA sample ; soda; lime.
5.2.3 Water pollution: turbidity, COD, BOD, heavy metals, radioactive substances and plastic
| Pollutant | Source and effect | Control |
|---|---|---|
| Turbidity (suspended clay, silt, organic matter), measured in NTU | Soil erosion, sewage; shelters microbes and reduces light | Coagulation (alum) and filtration |
| Organic matter (BOD, COD) | Domestic sewage and food industries; consumes dissolved oxygen, fish die and water turns anaerobic | Biological treatment |
| Heavy metals (, , , , ) | Mining, tanneries, electroplating; bioaccumulate and are toxic (Minamata disease from Hg, itai-itai from Cd; arsenic causes skin lesions and cancer) | Precipitation as hydroxides or sulfides, adsorption, ion exchange, membranes |
| Radioactive substances (, , , uranium) | Nuclear plants, mining, medical waste; cancer and genetic damage | Storage in shielded containers, ion exchange, dilution is not allowed for long-lived isotopes |
| Plastics and microplastics | Packaging litter, synthetic fibres, cosmetics; harm aquatic life and enter the food chain | Reduction and recycling, bans on single-use plastics, filtration |
Dissolved Oxygen, BOD and COD
- Dissolved oxygen (DO): oxygen dissolved in water ( at ); healthy water has .
- Biochemical oxygen demand (BOD): the oxygen consumed by microorganisms to oxidize the biodegradable organic matter in a sample, usually measured over days at (BOD): . Drinking water: below ; treated sewage: below for discharge.
- Chemical oxygen demand (COD): the oxygen equivalent of all matter (biodegradable or not) that is oxidized by hot acidic potassium dichromate. It is determined by back-titration with ferrous ammonium sulfate (FAS):
with and the volumes of FAS for the blank and the sample, and its normality. COD BOD, and the ratio shows how biodegradable the waste is.
5.2.4 Industrial wastewater and its treatment
Industrial wastewater contains acids and alkalis, oils, dyes, metals, solvents and organic matter that vary by industry (textiles, tanneries, paper, food, electroplating). The treatment sequence is:
- Preliminary: screening and grit removal, oil and grease traps, equalization of flow and neutralization of pH.
- Primary: sedimentation (settling tanks) and coagulation-flocculation (alum or ferric chloride) remove suspended solids and part of the BOD.
- Secondary (biological): the activated sludge process, trickling filters or anaerobic digesters let bacteria oxidize the dissolved organic matter ( falls by to ).
- Tertiary (advanced): sand filtration, activated carbon adsorption, membrane processes (reverse osmosis), chemical precipitation of heavy metals, nutrient removal, and disinfection by chlorine, ozone or UV light.
- Sludge handling: thickening, anaerobic digestion (to biogas), drying and safe disposal.
5.3
In a COD test, of wastewater needs of FAS while the blank needs . In a BOD test, a sample diluted (dilution factor ) has initial and . Find the COD, the and the ratio BOD/COD.
COD:
BOD and ratio:
A ratio below shows that only a small part of the organic matter is readily biodegradable, so a purely biological treatment would not be enough.
; ; .
5.3 Air pollution: particulate matter, SOx, NOx, GHGs, VOCs, their impacts and remedies
| Pollutant | Sources | Impacts | Remedies |
|---|---|---|---|
| Particulate matter (, ) | Dust, brick kilns, vehicles, biomass and crop burning | Lung and heart disease; haze; reduced visibility | Electrostatic precipitators, bag filters, cyclones, dust suppression, cleaner kilns |
| (, ) | Burning of sulfur-containing coal and oil; smelting | Respiratory disease, acid rain (), damage to marble and metals | Low-sulfur fuel, flue-gas desulfurization (wet limestone scrubber) |
| (, ) | High-temperature combustion: , then | Photochemical smog, acid rain, lung damage | Catalytic converters, SCR, lower combustion temperature |
| Greenhouse gases (, , , CFCs) | Fossil fuels, livestock, rice fields, landfills, fertilizers, refrigerants | Global warming, glacier melting and sea-level rise; CFCs also deplete ozone | Renewable energy, energy efficiency, afforestation, biogas capture, carbon capture, ban on CFCs |
| Volatile organic compounds (benzene, toluene, formaldehyde, solvents) | Paints, solvents, petrol vapour, industry | Photochemical smog, ground-level ozone, cancer (benzene) | Vapour recovery, adsorption on activated carbon, catalytic oxidation, low-VOC paints |
Greenhouse effect. The earth absorbs sunlight and re-radiates infrared; , , , water vapour and CFCs absorb this infrared and warm the atmosphere. On a -year basis, methane has about times and nitrous oxide about times the warming effect of per unit mass (IPCC AR5).
Flue-gas desulfurization. removes to of the and gives gypsum, which is used in plaster and cement.
5.4 Waste management
5.4.1 Segregation and management of solid waste
Municipal solid waste (MSW) consists of biodegradable waste (kitchen and garden waste, about to of the waste in cities of Nepal), recyclables (paper, plastic, glass, metal), hazardous waste (batteries, chemicals, medical waste) and inert waste (construction debris, ash).
Segregation at source into at least three bins (green for biodegradable, blue for recyclable, red for hazardous) is the first step because mixed waste is hard to treat. The waste hierarchy is: reduce, reuse, recycle, recover (energy), and finally dispose (sanitary landfill). Methods are:
- Composting of biodegradable waste to manure,
- Recycling of paper, plastic, glass and metals,
- Incineration with energy recovery for non-recyclable combustible waste (with flue-gas cleaning, since it produces , and dioxins),
- Sanitary landfill (lined, with leachate collection and landfill-gas capture) for the remainder.
5.4.2 Management of biodegradable waste into energy
In anaerobic digestion, bacteria break down biodegradable matter without oxygen in four stages (hydrolysis, acidogenesis, acetogenesis, methanogenesis) to give biogas ( to , to ) and a nutrient-rich slurry that is used as fertilizer. For a carbohydrate:
The methane burns as with . Biogas plants of household and community size are widely used in Nepal for cooking, and waste-to-energy plants for municipal waste, so the same process gives energy, reduces methane emission from landfills and produces manure. Other routes are fermentation to bioethanol, pyrolysis and gasification (conversion of dry waste to syngas ).
5.4.3 E-waste and its management
E-waste is discarded electrical and electronic equipment (computers, phones, televisions, batteries). It contains valuable metals (, , , , rare earths) and toxic substances: lead (solder, CRT glass), mercury (switches, lamps), cadmium (batteries), brominated flame retardants and (dioxins when burnt).
Management: reduce and extend the life of products (repair, reuse), extended producer responsibility (the manufacturer takes back the product), collection and safe transport, manual dismantling and sorting, recycling by mechanical separation, hydrometallurgical recovery (leaching of and with acids or cyanide-free reagents) and pyrometallurgy in controlled smelters, and secure disposal of the hazardous fraction. Open burning and acid-bath recovery in the informal sector release toxic fumes and must be avoided.
5.4
(a) Estimate the biogas methane produced from of glucose-equivalent waste () and its heat of combustion (: , molar volume at STP). (b) A power station burns of coal containing sulfur (). Find the mass of formed and the mass of () needed for removal.
(a) Biogas from glucose: and .
(b) and limestone: , so and gives .
(a) of giving ; (b) of needs of .
Exercises
Practice Exercises — Sustainable Chemistry
State six principles of green chemistry with an example of each.
Principles with examples: Prevention (design the process so that no waste forms); atom economy (direct oxidation of ethylene to ethylene oxide, ); safer solvents (water or supercritical instead of chlorinated solvents); energy efficiency (reactions at room temperature, microwave heating); catalysis (zeolite or enzyme instead of a stoichiometric reagent); renewable feedstocks (biodiesel from vegetable oil); design for degradation (biodegradable polylactic acid).
Any six of the twelve principles with a relevant example.
A sample of water contains () and (). Find temporary, permanent and total hardness in ppm of .
Conversion:
Totals: Temporary , permanent , total .
, and .
Explain scale and sludge formation in boilers, the harm they cause, and describe the zeolite process for softening water with the reactions used and the regeneration of the bed.
Scale and sludge: Scale is a hard adherent deposit of , or formed when the salts become supersaturated on evaporation; sludge is a soft, loose precipitate that settles in cooler parts. Scale has low thermal conductivity, so fuel is wasted, the tube metal overheats and may burst, and the flow is reduced; sludge chokes pipes.
Zeolite process: Hard water is passed through a bed of sodium zeolite, : and . When exhausted the bed is regenerated with a solution: .
Zeolite exchanges for and and is regenerated with brine.
Define BOD and COD. of an effluent needs of FAS and the blank needs ; find the COD. A sample diluted has and ; find .
Definitions: BOD is the oxygen needed by microorganisms to oxidize biodegradable organic matter in days at . COD is the oxygen equivalent of all oxidizable matter measured with hot acidic dichromate.
Numbers:
; .
Name the major greenhouse gases and the harm of acid rain. Show with balanced equations how and produce acid rain, and find how many moles of are in of methane and its warming effect in -equivalent (use a global warming potential of ).
Gases and acid rain: , , , CFCs and water vapour are greenhouse gases. Acid rain lowers lake and soil pH, kills fish and forests and corrodes marble and metals.
Methane: , and the -equivalent is of .
of ; equivalent to of over years.